bplan Pegasos II Instruction Manual page 15

not be any entry or possibly a QDHO partition. If there is such a
partition, «Delete» it by clicking on the appropiate button.
5. Next, add two partitions. One for MorphOS, one for your applications
and personal files:
0
Partition
(MorphOS)
Set up a new partition by
0
clicking on the «Add» button.
Enter a name for the partition
0
(for example, "bootO").
Specify its size as 256 Mbytes.
0
Select "FFS" (Fast File System)
0
as the filesystem for this
partition.
Replace the given mask value
0
"Oxfff ff ff f ' with "Oxfff ff ff e ".
(Please ignore any requesters
saying that this setting might
not be optimal.)
Set the check mark for the
0
"Boot" option.
Set the check mark for the
0
"Mount" option by clicking on
it.
Set the Buffers value to 600.
0
Click on the «OK» button.
0
Note: If the space on "Partition
create additional partitions at any time. In order to do so, repeat the
same steps as described for setting up "Partition 1". The maximum size of
additional partitions depends on the size of your harddisk.
1
Partition
Set up a second partition by
0
clicking again on the «Add»
button.
Enter a name for the partition
0
(for example, "hdO"). Make sure
that the name is not identical
with the name entered for
"Partition 0".
Type in a size for this partition.
0
(If you are unsure what size
would be best, 4096
Megabytes should be sufficient
as a start. You may still add
new partitions for your data
later-on.)
Select "SFS" (Smart File System)
0
as the filesystem for this
partition.
Set the mask value to "Oxfff ff ff e "
0
as you did for the other
partition.
Remove the check mark for the
0
"Boot" option.
Set the check mark for the
0
"Mount" option.
Set the Buffers value to 600.
0
Click on the «OK» button.
0
1 n
is not enough for your data, you may
15