Motorola XT420 Non-Display User Manual page 38

simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone "Cloning" is
heard.
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release the SB1 button.
4. After cloning is completed, the Source radio
announces either "successful" (cloning is
successful) or "fail" (cloning has failed). If the
Source radio is a display model, it either shows
'Pass' or 'Fail' on the display (a tone is heard
within 5 seconds).
5. Once you have completed the cloning process,
turn the radios OFF and ON to exit the 'cloning'
mode.
Further details on how to clone radios are
explained in the Instructions Sheet provided
with the MUC.
36
English
When ordering the MUC, refer to P/N#
PMLN6385_.
Notes:
• If cloning fails, refer to "What To Do If Cloning
Fails" on page 39.
• Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
• MUC pockets numbers should be read from left to
right with the Motorola Solutions logo facing front.
• A radio which is programmed with the expanded
frequencies (446.00625 MHz–446.19375 MHz)
will not support cloning to legacy eight frequency
radios.