Dyson Pure Humidify+Cool User Manual page 9

Deep cleaning your machine
– continued
4
Replace the cap and secure the cap
clips in place.
Wipe off any excess water to avoid
drips.
7
Unclip the cap, take the evaporator
out of the water tank and rinse under
a cold tap.
Wipe away any excess water to avoid
drips and place the evaporator to
one side.
Rinse the water tank under a cold
tap. Wipe the inside of the tank to
remove any excess solution and any
debris.
5
Slide the water tank into your
machine until it clicks securely in
place.
When prompted by the LCD screen,
press the Deep clean cycle button.
The Deep clean cycle will start
and the LCD screen will show a
countdown timer.
8
MAX
level
Refill the water tank to the Max level
and wipe off any excess water and
replace the cap, making sure that the
cap clips are secured.
9
Push the evaporator back into your
machine, making sure that it is
securely in position.
Close the inner door and replace the
shrouds.
9
6
When the LCD screen shows the
Deep clean cycle is complete, push
down the water tank release buttons
on the sides of your machine.
Slide the water tank out of your
machine. Carry the water tank
by its handle to the tap.
Slide the water tank back into
your machine and make sure it is
securely in place.