Advertisement
Quick Links
Advertisement
Related Manuals for Chesney's EFB1200
Summary of Contents for Chesney's EFB1200
- Page 1 CHESNEY’S Configuration of EFB1200 with Wi-Fi and Smart Home System manual Issue 01...
- Page 2 CONFIGURATION WITH WIFI AND SMARTPHONE For a configured appliance the following functions are available: - Turn on the appliance (if READY message is on display). - Turn off the appliance (if COOLING THE DEVICE or READY message is on display) - Increase or lower the flame height of the appliance during use.
- Page 3 Instead of ‘Wi-Fi Network Name’ - enter the name of the network, e.g. ‘home’. Wi-Fi Network Password - password to the network, e.g. ‘mynet’. Example: Make sure that the appliance is disconnected from the mains then insert the USB flash drive to USB port on the side part of the product. USB PORT Connect the appliance to the mains and wait a minimum of 5 minutes.
- Page 4 The assigned IP address is a dynamic address and is subject to change in the event of a change in the network settings. It may happen that the displayed IP is incorrect. In such a case follow the instructions below: 0.0.0.1 No communication with It is normal during the initialization of the...
- Page 5 - cut the band that is clipping the cable - take out the cable with the WiFi transceiver at its end - repeat the connection procedure NOTE: The cause of failure to configure can be ascertained by reading the file ‘wifi.txt’. Network parameters changed The change of all the network parameters was successful...
- Page 6 The display will appear on the device: Appliances can be individually named so that specific appliances can be selected where more than one has been installed. Activates ‘LOCK THE DEVICE’ function (see: User’s Manual, III. Customer’s Menu, 1.)
- Page 7 Using the SETTINGS function it is possible to determine: - Serial number - Display and microprocessor’s program version - Total time of appliance operation - Website version...
- Page 8 Using MANAGER function it is possible to control an unlimited number of configured appliances. NOTE: In order to successfully operate the appliance it is essential that the user is familiar with the User’s manual and that the appliance has been installed in accordance with the instructions contained in the Installation manual.
- Page 9 SMART HOME SYSTEM CONNECTION When the Smart Home System driver is installed, it can be used to: - Turn on the appliance (if READY message is on display). - Turn off the appliance (if COOLING THE DEVICE or READY message is on display) - Increase or lower the flame height of the appliance during use.
- Page 10 All the ports have been adjusted to work within direct current voltage of 12V-24V. Higher voltage requires the use of an additional limiter installed on the module’s port. More than one appliance can be controlled simultaneously. In order to do so, it is essential to divide the signal, using one for each appliance.
- Page 11 MODE OF OPERATION. Following connection in accordance with the foregoing instructions, control of the appliance takes place via the emission of single and short electrical impulses (lasting from 100ms to 1s) to the electrical connectors. A single impulse directed to the START port turns on the appliance (when stand-by mode is activated manually with the button).
Need help?
Do you have a question about the EFB1200 and is the answer not in the manual?
Questions and answers