Test The System - Logitech Z906 Complete Setup Manual

TEST THE SYSTEM

To test if you have correctly set up your speakers, press and
hold the INPUT button on the remote control or control
console for 5 seconds to put your system into test mode
In test mode, the system cycles through each speaker,
playing an audible test signal The test signal comes
from only one speaker at a time, in 5-second intervals,
in the following order: left front, center, right front, right rear,
left rear, and subwoofer
As a channel is tested, its corresponding LED lights up on
the front panel of the control console The test signal cycles
through each speaker one time and stops To re-enter test
mode, press and hold the INPUT button on the remote
or control console for 5 seconds
SELECT AUDIO INPUT
Use the remote control or the control console to select
an input source Pressing the INPUT button cycles
through the various audio input sources The numbers
of inputs showing on the control console correspond to
the connections number on the back of the subwoofer
If you're using a digital connection, follow the instructions on
your audio source to make sure you're getting digital audio
output For digital content, the control console automatically
detects and displays the digital stream as long as the device
is connected to a digital input For example, if you have
selected the DTS Digital Sound or Dolby Digital 5 1 stream for
a DVD you want to watch, it will be detected automatically
when you choose the applicable input
INPUT MUTE
LEVEL
EFFECT
INPUT DOLBY
1
2
STEREO
3
4 3D
5 4.5
AUX 2.1
INPUT EFFECT MUTE LEVEL
English 7