Baseline 300 Safety Instructions, Set Up Instructions, Operation Instructions, Maintenance Instructions page 13

11.
Push the bead lifting tool down towards the wheel
to lift the tire bead up and over the knob portion of the
mount/demount tool. Hold the bead lifting tool and
tire bead in this position (figure 14).
Figure 14 - Lift Tire Bead Over Duckhead
Tool Knob
12.
Depress the table top pedal to rotate the wheel.
The Duckhead mount/demount tool will guide the
®
tire bead up and over the edge of the wheel. Continue
rotation until the upper bead is demounted.
Push down on the tire across from the mount/
demount tool during table top rotation to utilize
the drop center area of the wheel. This reduces
the tensional force on the top or first bead
during demount (figure 13).
Figure 15 - Demounting Lower Bead
Important: Always read and follow operating instructions.
13.
lower bead is resting in the drop center directly across
from the mount/demount tool, and is loose below the
mount/demount tool (figure 15). Insert the smooth
curved end of the bead lifting tool down over the for-
ward end of the mount/demount tool and below the
lower bead. Lift the bead up and over the knob on the
mount/demount tool (figure 16).
Mount/Demount
®
Figure 16 - Guide Lower Bead Over Tool Knob
14.
The mount/demount tool will guide the bead up and
over the edge of the wheel. Continue rotation until
lower bead is demounted.
Lift and hold the tire at an angle so that the
Depress the table top pedal to rotate the wheel.
With tube-type tires, demount the upper bead
and remove the tube before demounting the
lower bead.
• 11