Baseline 300 Safety Instructions, Set Up Instructions, Operation Instructions, Maintenance Instructions page 11

Figure 6 - Position Tire and Bead Loosener Shoe
3.
Turn the wheel around and repeat loosening pro-
cedure on the other side of the wheel (figure 7). This
should be the long side of the drop center (figure 5).
Figure 7 - Position Tire and Bead Loosener Shoe With Wheel
Turned Around
It will be easier to outside clamp the wheel to
the table top if the long side of the rim is loos-
ened last.
4.
Apply tire manufacturer's approved rubber lubri-
cant liberally to entire circumference of both tire
beads after loosening (figure 8).
Figure 8 - Apply Rubber Lubricant to Tire Beads
Important: Always read and follow operating instructions.
5.
Determine the mounting side of the wheel. The
mounting side is the narrow side of the drop center.
See figure 2 for more information on the drop center.
6.
Place tire/wheel assembly on table top with
mounting side up (figure 9). Use the clamp control
pedal to move the clamps inward (push pedal down)
or outward (toggle pedal up). Clamp steel wheels
from the inside (clamps push outward against wheel).
Clamp mag and custom wheels from the outside
(clamps push inward against the outside rim edge).
Figure 9 - Place Tire/Wheel Assembly on Table top
7.
Move the swing arm into position. Pull the locking
handle forward to release the slide. Push down on the
top of the vertical slide to move the mount/demount
tool into contact with the rim edge. Push the locking
handle back and lock the slide into place (figure 10).
Figure 10 - Position Mount/Demount Tool
.
• 9