Table of Contents
Advertisement
Setting up the
transmitter
1
Connect the transmitter to audio/video
equipment. Select one of the hookups
below depending on the jack type:
To connect to a headphones jack
Set the INPUT SOURCE selector to
PHONES.
INPUT SOURCE
LINE
PHONES
to AUDIO IN A jacks
Right channel
(red)
Connecting cord
(supplied)
Unimatch plug
adaptor
(supplied)
to headphones
jack (stereo
phone jack)
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
SECTION 1
GENERAL
Transmitter
DC IN 9V
B
R
A
L
AUDIO IN
Left channel
(white)
to headphones
jack (stereo
mini jack)
CD Walkman,
MD Walkman,
WALKMAN*,
TV, VCR, etc.
— 2 —
ATT (attenuator) selector
If a loud sound is distorted when the transmitter
is connected to an audio output jack other than
the headphones jack, set the ATT selector on the
transmitter to -12 dB. The default setting of the
ATT selector is 0 dB.
ATT selector
ATT
0dB
–12dB
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
This section is extracted
from instruction manual.
Advertisement
Table of Contents
