Related Manuals for Russell Hobbs RHESB6001
Summary of Contents for Russell Hobbs RHESB6001
- Page 1 Electric Blanket Model Number: RHESB6001 - 60W RHEDB6002 - 90W RHEKB6003 - 2 x 60W 220-240V AC 50Hz PLEASE RETAIN FOR FUTURE REFERENCE...
-
Page 2: Table Of Contents
CONTENTS Page(s) Safety Instructions and Electrical Safety 3 - 5 Securing your Electric Blanket Feature Diagram Using your Electric Blanket 8-10 Controls Cleaning and Care 11-13 Problem Solving Guarantee and Customer Services Connection to the Mains Supply Specification Notes 18 - 19 Disposable Information Page 2... -
Page 3: Safety Instructions And Electrical Safety
SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be observed, including the following: • Read all instructions. • Check that your mains voltage corresponds with the rating on the appliance. • To protect against electrical shock do not immerse cord, plug, or appliance in water or other liquid. - Page 4 SAFETY INSTRUCTIONS • Make sure that the heating area (wire element) on any side of the bed does not hang over the edge of the mattress and that the following instructions are read carefully before using the blanket. • Do not use this blanket for infants, persons with no/limited mobility or heat sensitivity conditions.
- Page 5 SAFETY INSTRUCTIONS • Do not switch the power on if the blanket is wet or in a folded state. • Do not dry-clean this blanket. Cleaning liquids may have a deleterious effect on the insulation or covering of the heating unit. It is recommended you follow instructions for localized soiling or hand washing if soiling occurs.
-
Page 6: Securing Your Electric Blanket
SECURING YOUR ELECTRIC BLANKET Note: • Use only as an under blanket and do not use above the occupant of the bed. • This product can be used with any type of bedding including waterproof bed protectors. • Tie this blanket securely to the bed. •... -
Page 7: Feature Diagram
FEATURE DIAGRAM 1. Electric blanket 4. Ties (these are located on 2. Detachable power cord the side of the blanket) 3. Controller For Customer Services & Spare Parts please call 0345 209 7461 Or visit us at https://mda.russellhobbs.com Page 7... -
Page 8: Using Your Electric Blanket
USING YOUR ELECTRIC BLANKET Controls Note: On initial use it is recommended that the blanket be set on setting ‘3’ for 1-2 hours before sleeping on the bed and then set to setting ‘1’ for continuous use. Preset on ‘3’ will assist in drying out any moisture which has been accumulated in the mattress. - Page 9 USING YOUR ELECTRIC BLANKET 1. Ensure the blanket is fitted to the bed correctly, see the Securing your electric blanket section. 2. Plug the power lead into the closest socket, using an extension lead, if needed, to ensure that the lead is not stretched. 3.
- Page 10 USING YOUR ELECTRIC BLANKET Safety Protective Devices The appliance is fitted with an over heat protection system The system will remain dormant indefinitely as long as the blanket is operating in the normal temperature range. If, for any reason, the blanket is operated in an abnormal situation or condition which would otherwise have induced a rapid temperature rise high enough to constitute a hazard, the over heat protection should intervene by cutting off the supply...
-
Page 11: Cleaning And Care
CLEANING AND CARE WARNING: Electrical Shock Hazard. Note: Before cleaning, ensure the control is set to the ‘0’ Position (OFF) and remove the plug from the wall socket. Note: Do not allow the controller to come in contact with any wet solution. - Page 12 CLEANING AND CARE Washing instructions Only use the below instructions: • Hand wash or spot clean • Do not machine wash above 40°c • Do not tumble dry • Do not wring • Do not bleach • Do not dry clean •...
- Page 13 CLEANING AND CARE • Rinse the blanket thoroughly in clean fresh water. • Unfolded the blanket and allow to dry naturally. Hand Washing • Immerse the blanket only (do not allow the controller to come in contact with any wet solution) in a luke warm neutral detergent or mild soapy solution.
-
Page 14: Problem Solving
PROBLEM SOLVING My appliance does not work when I turn it on: 1. Check that your appliance is plugged in and the power is turned on at the mains socket. 2. Try another mains socket. 3. Check that the control has been set to the correct setting and is not in the off position 4. -
Page 15: Guarantee And Customer Services
GUARANTEE AND CUSTOMER SERVICES At Russell Hobbs, we take all our customer feedback seriously. Feel free to contact our Customer Service Team, on 0345 209 7461, who will be more than happy to assist you. This product is guaranteed for 12 months from the date of the original purchase. -
Page 16: Connection To The Mains Supply
CONNECTION TO THE MAINS SUPPLY This appliance is designed to operate from a mains supply of 220-240V~50Hz. Check that the voltage marked on the product corresponds with your supply voltage. How to change the fuse 1. Slot the end of a screwdriver into the recess in the fuse holder of the plug. -
Page 17: Specification
SPECIFICATION Model number RHESB6001 Rated voltage 220V - 240V ~ 50Hz Power consumption Product dimensions (CMS) (W)70 x (L)150 Model number RHEDB6002 Rated voltage 220V - 240V ~ 50Hz Power consumption Product dimensions (CMS) (W)140 x (L)150 Model number RHEKB6003... -
Page 18: Notes
NOTES Page 18... - Page 19 NOTES Page 19...
-
Page 20: Disposable Information
Parts please call 03452097461 Or visit us at https://mda.russellhobbs.com Revision 1 Model Number: RHESB6001 RHEDB6002 RHEKB6003 This symbol is known as the 'Crossed-out wheelie bin Symbol'. When this symbol is marked on a product/batteries, it means that the product/batteries should not be disposed of with your general household waste.