Installation - Maxwell HRC10 Manual

INTRODUCTION
• Read this manual thoroughly before installation and
using the windlass. Failure to adhere to the correct
procedures, recommendations
described in this Owner's Manual may invalidate the
warranty.
• Correct selection of windlass together with correct
installation, care in use and maintenance, are
essential for long life and reliable performance.
• In addition to this instruction manual, the following
components should be included with the windlass:
• Clutch Handle
• Deckplate Gasket
• Deck Cutout Details (at rear of manual)
• Deck stud Kit
- Studs
- Nuts
- Flat washers
- Spring washers
The following accessories may be required to
complete your installation:
• Remote up/down control panel
• Circuit breaker/isolator panel
• 12V or 24V reversing solenoid
IMPORTANT INFORMATION
• The windlass must have a minimum pull capacity of
three times the combined weight of the anchor and
rope/chain.
• Keep hands, feet, loose clothing and hair well clear of
the windlass and rope/chain during operation.
• Never operate the windlass from a remote station
without having a clear view of the windlass.
• Do NOT use the windlass as a mooring point. When
anchoring or mooring, secure the line directly to a
bollard or deck cleat.
• Do NOT use the windlass to pull the boat forward
when raising the anchor. Use the boat's engine to
drive the boat up to the anchor.
• Do NOT attempt to break free a fouled anchor with the
windlass. Secure the line to a bollard or cleat and use
the boat's engine to break the anchor out.
• Always firmly tie down the anchor when under way or
in heavy seas. Do not rely on the windlass as a
securing device.
• Always turn the circuit breaker/isolator switch off when
the windlass is not in use and before you leave the
boat.
• Do NOT use the windlass to haul a person up a mast.
Maxwell Marine International Ltd – HRC10 Series
ROPE AND CHAIN SELECTION
Correct fit of rope and chain to chainwheel is essential for
and guidelines
the windlass to operate properly.
The ground tackle should be selected taking into account:
a) Boat size, displacement and windage.
b) Conditions of operation such as maximum depth of
water, type of bottom and likely weather conditions.
c) Holding power and size of anchor, taking special note
of the manufacturers' recommendations.
Selection of chainwheel:
Part Number P103315 for :
HRC10-8: 14mm (9/16")-16mm (5/8") rope / 8mm (5/16")
chain
Part Number P103316 for :
HRC10-10: 14mm (9/16")-16mm (5/8") rope / 10mm (3/8")
chain

INSTALLATION

• For automatic operation to be possible, the anchor
must be self launching.
•
Tie the end of the anchor rope/chain to a secure
fixture in the rope/chain locker.
Foredeck layout
Ensure the deck is flat, if not; a plinth (A) will be required to
ensure the windlass sits on a flat surface.
Required clearances
Identify any bulkheads, wiring or piping under the deck that
should be avoided.
Position the windlass so the rope/chain falls directly into
the
unobstructed fall.
A
rope/chain locker with at least 200mm (8")
1