Dip Switch Settings - Magnetic Autocontrol MAGSTOP MBE35 Operating Instructions Manual

MBE35_50 OPERATION MANUAL 2005_10

4.5 DIP Switch settings

Additional functionality can be set by switching the DIP-switches 1-8 in certain
positions:
ON
1 2
Dip Switch Function
1 OFF
After return of power the gate moves to the up position
and a manual reset using the reset button is required
1 ON
Activates the RESET functions of DIPswitch 2.
2 OFF
Signal reset. When the gate was in the up position before
the power turned off, and still is after the power returned,
the gate will stay up and only pressing the reset button at
the controller, a down command, or passing of the safety-
closing device will reset the gate to go down. If the gate
was in the fully closed position (down limit switch
activated) before the power went off, and still is when the
power returned, the gate will remain in the down position
2 ON
Auto reset. The gate will close immediately after the
power is restored as long there is no vehicle or
pedestrian (if IN4 is used) in the detection zone.
ATTENTION: If the power was restored while a vehicle
was on the induction safety loop any loop detector will
read this vehicle as part of the loop and will not detect the
vehicle when the gate comes down. This will cause the
gate to hit the vehicle!
3 OFF
In this switch setting there is no closing delay, i.e. the
and gate closes immediately after a closing command was
given on IN3 or a vehicle passed through the safety
4 OFF
closing zone
3 ON
In this switch setting the closing delay time is set to 2
and
sec. When a closing command on IN3 was given or a
vehicle passed through the safety-closing zone the
4 OFF
closing delay timer will start and the gate will not close
until the timer is elapsed.
3 OFF
In this switch setting the closing delay time is set to 5
and
sec. When a closing command on IN3 was given or a
vehicle passed through the safety-closing zone the
4 ON
3 4 5 6
Operation Instructions
ON
7 8
20