Magnetic Autocontrol MAGSTOP MBE35 Operating Instructions Manual page 17

Operation Instructions
MBE35_50 OPERATION MANUAL 2005_10
1. Disabling of safety/closing devices connected to IN5 when the gate is in
the down position.
2. The limit switch provides the controller logic with the information that the
gate is in the down position.
3. If the controller is setup for signal reset (see
uses the limit switch feedback to determine in what position the gate is
when the main power returns after it was off.
4. If a warning signal is used on output relay K 3 (see
the signal will stay on for 5sec. after the controller received the feedback
from this limit switch that it is in the down position.
chapter 4.5 DIP Switch 2) it
chapter 4.3 and 4.5)
- 17 -