30" electric explosion proof fan on 4' stand 8723 cfm - 30" - pedestal mount - 100' cord - c1d1 (3 pages)
Summary of Contents for Larson Electronics IND-HVAC-DTW-UVC-R1-SS Series
Page 1
The information and recommendations contained in this publication are based upon data collected by Larson Electronics and are believed to be correct. However, no guarantee or warranty of any kind, expressed or implied, is made with respect to the information contained herein. Specifications and information are subject to change without notice.
IND-HVAC-DTW-UVC-R1-SS series SAFETY WARNINGS • All personnel should be alerted to the potential hazards indicated by the product safety labeling on this unit. • The following conventions are used to indicate and classify precautions in this manual and on product safety labeling.
IND-HVAC-DTW-UVC-R1-SS series SAFETY LABELS Danger Label: Hazardous Voltage and Ultraviolet Radiation (70-0038) Location of Danger Label Location of Danger Label CAUTION It is the user’s responsibility to determine and validate the suitability of this equipment for use in the user’s system or process.
Page 4
Remove the Air Duct Disinfection Unit from its shipping carton. • Larson Electronics takes all possible precautions when packaging this unit to prevent damage. Carefully inspect the unit, power cord and plug for damage and report all damage immediately. Do not assemble or operate if there is any damage, visible or suspected.
IND-HVAC-DTW-UVC-R1-SS series The 2 unit includes: • 1 - 2 lamp unit with line cord • 2 - Germicidal Ultraviolet Lamps • 4 - No. 8-18 x ½” Self-Drilling Screws • 1 - 2-in. Sight Glass Assembly with 4 - No. 8-18 x 3/8” Self-Drilling Screws •...
Page 6
IND-HVAC-DTW-UVC-R1-SS series Figure 1 – Unit Placement Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 6 of 10...
Page 7
IND-HVAC-DTW-UVC-R1-SS series INSTALLATION ADHO Figure 2 – Unit Installation - Outside Duct Mount Opening for outside mount (shown) - use full Insert unit. Attach unit using the face mounting size template on page 15 and 16 to cut opening. bracket and self-drilling screws.
Page 8
IND-HVAC-DTW-UVC-R1-SS series UNIT AND LAMP INSTALLATION, REPLACEMENT, OR CLEANING IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES. WARNING Always disconnect power to the unit before performing any service or maintenance.
• For proper germicidal lamp replacement and cleaning procedure see “Unit and Lamp Installation, Replacement,or Cleaning” on Page 8. • Contact Larson Electronics with questions. BREAKAGE CAUTION Broken Quartz is SHARP. Wear protective gloves when handling broken ultraviolet lamp(s). In the event of breakage, DO NOT use a household vacuum cleaner to pick up quartz fragments.