Summary of Contents for Larson Electronics IND-HVAC-DTW-UVC-R1-SS Series
Page 1
The information and recommendations contained in this publication are based upon data collected by Larson Electronics and are believed to be correct. However, no guarantee or warranty of any kind, expressed or implied, is made with respect to the information contained herein. Specifications and information are subject to change without notice.
IND-HVAC-DTW-UVC-R1-SS series SAFETY WARNINGS • All personnel should be alerted to the potential hazards indicated by the product safety labeling on this unit. • The following conventions are used to indicate and classify precautions in this manual and on product safety labeling.
IND-HVAC-DTW-UVC-R1-SS series CAUTION It is the user’s responsibility to determine and validate the suitability of this equipment for use in the user’s system or process. No warranty or representation is made by the manufacturer with respect to suitability or performance of this equipment or to the results that may be expected from its use.
Page 4
Remove the Air Duct Disinfection Unit from its shipping carton. • Larson Electronics takes all possible precautions when packaging this unit to prevent damage. Carefully inspect the unit, and power cord for damage and report all damage immediately. Do not assemble or operate if there is any damage, visible or suspected.
IND-HVAC-DTW-UVC-R1-SS series INSTALLATION UNIT PLACEMENT • Proper unit placement is essential. To ensure safe and effective operation, the location should: • Have enough duct width to mount unit with lamps perpendicular to airflow, within the longest duct length for increased exposure time.
Page 6
IND-HVAC-DTW-UVC-R1-SS series INSTALLATION Figure 2 – Unit Installation - Outside Duct Mount Opening for outside mount (shown) Insert unit. Attach unit using the face mounting bracket and self-drilling screws. View inside duct. Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com...
Page 7
IND-HVAC-DTW-UVC-R1-SS series UNIT AND LAMP INSTALLATION, REPLACEMENT, OR CLEANING IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES. WARNING Always disconnect power to the unit before performing any service or maintenance.
10,000 hours of operation or about one (1) year of continuous use. • Unless lamp replacement is due to failure or breakage, it is recommended that all lamps be replaced at the same time. • Contact Larson Electronics with questions. Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com...
(LEDs) not operating. THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.