Table of Contents
Advertisement
1.
Make sure the unit is unplugged and then fill the water tank with water.
2.
Turn the water tank cap counter-clockwise to the open "OFF" position then remove
the cap as shown in Fig la, 1b, 1c & Id.
1a
1c
3.
Hold the mop at a 45° angle as shown in Fig Id and add water to the tank up to the
MAX level by using the measuring cup. Do not overfill. The maximum tank capacity
is 450ml.
4.
Replace the water tank cap and turn clockwise approximately 90° to the "CLOSE"
position until the cap is tightened securely.
1b
1d
Advertisement
Table of Contents
