Changing The Scanning Mode - JVC UX-GD7 Instructions Manual

Hide thumbs Also See for UX-GD7:

Přiručka k obsluze (53 pages)

Instructions manual (52 pages)

Service manual (46 pages)

Table Of Contents

100

101

Table of Contents

To assemble and connect the AM loop antenna

To assemble the AM loop antenna

To connect the AM loop antenna

1 Hold

2 Insert

• If the AM loop antenna wire or speaker cords are covered

with vinyl, remove the vinyl to expose the tip of the

antenna by twisting the vinyl.

• Make sure the antenna conductors do not touch any other

terminals, connecting cords and power cord. Also, keep the

antennas away from metallic parts of the System,

connecting cords, and the AC power cord. This could cause

poor reception.

To connect the speaker cords

Connect the right speaker to the R terminals, and the left

speaker to the L terminals.

1 Press and hold

2 Insert

When connecting the speaker cords, match the polarity of

the speaker terminals: gray cord (+) to red (+) and gray cord

with black stripe (–) to black (–).

• DO NOT connect more than one speaker to

each terminal.

• DO NOT allow the conductor of the speaker

cords to be in touch with the metallic parts of

the System.

To set the video output selector

You can select the video output to match it to the color

system of your TV.

NTSC

PAL

Adjusting the voltage selector

3 Release

Use a screwdriver to slide the voltage selector so that the

voltage marker is pointing at the same voltage as where you

are plugging in the unit. (See also the back cover page.)