Remote Controller Installation - LG UU21WH Installation Manual

Remote Controller Installation

1. Connect the remote controller cable to the
wired remote controller installation board as
shown in the right picture.
12V
SIG
GND
❊ The remote controller cable is connected as factory default.
2. After fixing the cable to the guide slot,
attach the wired remote controller
installation board at the desired location.
• Before fixing the remote controller cable to the
guide slot, remove any clogged part of the case
in the direction to install before the installation.
3. After locating the wired remote controller
installation board at the desired location,
screw the unit firmly. (When there is a buried
box, install the wired remote controller
board to fit the buried box.)
• Use the screws provided.
4. After fixing the top part of the remote
controller to the installation board as shown
in beside picture, press the bottom part to
assemble the controller to it's board.
When disassembling the remote controller from
the installation board, use the driver as shown in
the right picture and insert it into the hole with the
arrow. And when you pull the driver in the front
direction, the remote controller will be separated.
12 Air Conditioner
Red wire
Yellow wire
Black wire
12V SIG GND
Red
Yellow
Black
<Front side of
installation board>
Top
Fixate the remote
controller cable
to the guide slot.
Bottom
Wall
Side
Wall
Side
Remote Controller
Cable
<Rear side of
installation board>
Use the screws
for fixate the unit
firmly on the wall.
Installation board
Wall
Side
Wall
Side
Guide slot
Wall
Side