Table of Contents
Advertisement
INSERT THE SMART CARD INTO THE DECODER
The smart card is licensed to your service provider. If you want to view conditional access programming, you must insert
a smart card in the slot. Insert the card all the way into the slot with the gold plated contact points on the card facing down
and pointing towards the decoder. The QS1080IR receiver series support Irdeto Conditional Access cards.
USING YOUR SMART CARD
Your service provider may encrypted some of its satellite channels. To view these channels, you have to purchase an
access package from your service provider. You also need to be sure that the smart card has been inserted into the slot on
the front of the decoder. The Smart Card is used to identify your decoder to the service provider and authorize you to
de-scramble satellite signals.
The QS 1080IR satellite decoder includes one smart card slot. Before inserting a smart card into these slots, please note
the following precautions:
•
Do not bend or twist the card.
•
Keep the card out of direct exposure to sunlight or any other heat sources.
•
Do not remove/insert the card repeatedly into the slot.
•
Clean the card only with soft dry tissue. Do not use liquids or detergents to clean it.
•
Record the card number for future reference in case the card is damaged or lost.
•
If the card is damaged or lost, contact your service provider for a replacement.
PHYSICAL INSTALLATION
Please always remember to disconnect the satellite decoder from the power source prior to connecting or disconnecting
the cable to the LNB (on the satellite dish).
When the decoder is connected to the satellite dish, it may supply voltage to the LNB. You should therefore disconnect the
decoder from the power receptacle before attaching the LNB or any other equipment.
7
Advertisement
Table of Contents
