Table of Contents
Advertisement
MAIN MENU
If the receiver has not been installed prior, the channel database will be empty. During the first time installation you will
see the message Database Empty, press menu for installation. Please press menu on your remote control.
INSTALLATION
CHANNEL SCAN (DiSEqC 1.0)
14
Initial Screen –
After power-up and pressing the menu button , it
will display the "Main MENU" and background.
● Use the cursor keys ▼▲ to move through
the menu, the SELECT button to choose specific
items, and EXIT button to return to the main menu
from submenus or leave the main menu.
● When you enter the "installation" menu to start the
channel scan. It's necessary to enter the password to go
into this menu.
● The default password is 0000.
● You may also change the password under the "Inst.
password" sub-menu.
Satellite settings:
•
Press the ◄ ► keys to select the dish antenna nr.
and it's corresponding DiSEqC position
•
Press "Select" to configure the satellite name,
LNB type and LNB power for the selected
DiSEqC position.
Transponder frequency settings:
•
Press the ◄ ► keys to select the (start) frequency
to be scanned. Selecting a pre-programmed
frequency automatically sets the polarity and
symbolrate.
The default transponder is set for the Euro1080 High
Definition channel.
Scan method:
Press the "Red" button to select the scan method.
"Single TP" scans one frequency. "NIT" scans all
frequencies in the NIT tables of the selected transponder.
"Single SAT" scans all pre-programmed frequencies for the
selected satellite. "Auto" scans all configured satellites.
Press the "Green" button to start scanning.
Advertisement
Table of Contents
