Remote Control - Quali-TV QS1080IR Manual

REMOTE CONTROL

The remote control provides easy access to all of the receiver's functions, including selecting channels and using the
menus. It uses infrared signals, and must be operated within seven meters from the receiver.
When using the remote control, be sure there is a direct line of sight to the receiver. Also note that although the receiver
can be operated from the buttons on the front panel, some of the receiver's functions can only be accessed using the
remote control. The batteries for remote control are packaged separately; please install these batteries in the remote
control before using the receiver. Note the +/- signs on the batteries to ensure that the batteries are inserted with the
correct polarity into the remote control. To avoid damage to the remote control, discard any depleted or old batteries.
The buttons on the remote control have the following functions
•
Mute Mute the audio
•
TTX Start Teletext or subtitling
•
Numeric Buttons
•
Standby Switches the receiver between ON and STANDBY modes
•
Info Displays I-Plate, providing information about the current channel
Press "Info" button key two times for extra information about the
Current and next program.
•
Audio Toggles between multi-lingual Audio soundtracks
•
Menu Activates the On-Screen Menu
•
List Displays the complete channel/program list
•
Fav. Displays the Favorite channel list
•
Cursor buttons To move through menus or submenus
•
Select Selects the highlighted menu or submenu item
•
CH+/CH－ Provides channel up and down functions
•
Vol+/Vol－ Increases or decreases audio volume
•
A.Ratio Adjusts the aspects ratio between 16:9 and 4:3
16:9 (4:3 pillar box)
4:3 (16:9 letter box)
4:3 (16:9 crop)
•
PIP The receiver is tuned to and allows displaying the second program
on the TV screen
•
TV / Radio Selects between TV program or Radio program
•
V.Format Press once, display current resolution. Press again toggle between 1080i, 720p, 576p and
PAL video format
•
Red button Change to the next satellite and it's channel list by pressing the red button.
•
Yellow but. Press once, display output mode: YpbPr or RGB. Press for 5 secs, change the output mode.
•
Blue button Start the Electronic Program Guide.
6
For entering channel numbers or password