Table of Contents
Advertisement
Operation
Continued from the previous page.
The engine's throttle lever (m) has a hole used for attaching a cable. The
Installing the
illustration below shows examples of attaching a solid wire cable (n) and a flexible,
throttle cable
braided cable (o). Use a screw (p), wire holder (q), and circlip (r) if using a flexible
cable.
Note: Add a return spring (s) as shown if using a flexible cable.
A special bend at the end of the solid wire cable allows it to slip into the hole on the
engine's throttle lever. No special hardware is required for this installation.
NOTICE: Loosen the throttle lever pivot nut (t) when operating the throttle via a
remote control.
1. Connect the electrical wires from the handle to the electrical wires from the
Final
engine.
assembly and
check
2. Start the engine and check the idle RPM. The specification is 1400±150 RPM.
3. Flip the centrifugal switch (d) to the OFF position to make sure the engine stops
if the handle is released.
s
t
o
k
n
q
p
o
s
20
MCT36-5 CN
m
p
q
r
wc_gr015125
wc_tx004557en.fm
Advertisement
Table of Contents
