Huawei FusionServer Pro 2488H V5 Technical White Paper page 27

Huawei FusionServer Pro 2488H V5 Server
Technical White Paper
Port
PSU socket
Table 5-5 LOM port description
Chip Model
X722
● Use
● The LOM ports support NC-SI and PXE.
● The LOM ports do not support forced rates.
● The electrical LOM ports cannot be connected to power over Ethernet (PoE)
● The electrical LOM ports do not support SR-IOV.
● Forcibly powering off a server will cause intermittent NC-SI disconnection
Issue 03 (2020-04-20)
Type
-
Port Type
10GE optical
port
GE electrical
port
Intelligent Computing Compatibility Checker
about the cables and optical modules supported by the LOM ports.
devices (such as a switch with PoE enabled). Connecting a LOM port to a PoE
device may cause link communication failure or even damage the NIC.
and disable the Wake on LAN (WOL) function of the LOM ports. To restore
the NC-SI connection, refresh the iBMC WebUI.
Copyright © Huawei Technologies Co., Ltd.
Quantity Description
2 Used to connect to the power
distribution unit (PDU) in the
cabinet. You can select the
number of power supply units
(PSUs) as required.
NOTE
● When determining the
● If only one PSU is used,
Rate Supported
Negotiation Rate
Mode
Auto- 10000M
negotiation
10000 Mbit/s
(full duplex)
Auto- 1000M
negotiation
1000 Mbit/s
(full duplex)
5 Hardware Description
quantity of PSUs, ensure that
the rated power of the PSUs
is greater than that of the
server.
Predicted PSU Status cannot
be set to Active/Standby on
the iBMC WebUI.
Rates Not
Supported
10/100/1000
M
10/100M
to obtain information
21