Dynojet POWER COMMANDER V Installation Instructions page 5

FIG.G
Unplug
FIG.H
Stk
FIG.J
25-013 www.powercommander.com
10 Locate the Throttle Position Sensor on the rear side of the throttle body
(Fig. G).
11 Unplug the stock wiring harness from the TPS.
12 Plug the PCV connectors in-line of the stock wiring harness and TPS (Fig. H).
13 Route the ground wire from the PCV to the left hand side of the throttle body
and follow the stock ground wires down to the right hand side of the engine.
14 Attach the ground wire from the PCV to the common ground lug of the engine
(Fig. J).
15 Reinstall the covers and the seat
2006-2016 Can-Am Outlander 650 - PCV - 5