Step 2 Inserting Additional Modules (Memory / M.2 - Fujitsu SMARTCASE S520 Assembly Instructions Manual

Assembly Instructions SMARTCASE S520

Step 2 Inserting additional Modules (Memory / M.2 / ...)

The following picture shows some possible M.2 modules
Speaker +
mount rubber
SATA + Power
cable
Attention: Do not touch any pins! Touch the memory at the outside edges only.
Do not stick a barcode onto any modules!
The following procedure is recommended in order to ensure secure electrical contact:
1. First insert the lower memory
angular and pay attention to the
notch!
2. Remove the memory again
completely from the DIMM socket!
3. Insert memory again
4. Press down the memory until it
clicks into place
5. Do not press in the middle of the
memory, but press down on the
outside edges only
6. Install the upper memory in the same way as the lower one.
__________________________________________________________________________________________________________________________________________________________
Page 4 of 12
M.2 2230
WLAN + Antenna
CPU
V1.1 - 07/2019
2,5" Storage / M.2 SSD 2280
Mainboard
Memory
lower
www.fujitsu.com