Table of Contents
Advertisement
Figure 27
1. Jam nut
6.
Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7.
Adjust the turnbuckle until you obtain the proper
gap.
8.
Tighten the jam nut.
9.
Insert the 2 screws that you previously removed
on the belt cover.
10.
If the auger/impeller cable is properly adjusted
but a problem remains, contact an Authorized
Service Dealer.
Checking the
Auger-Gearbox-Oil Level
Service Interval: Yearly—Check the auger-gearbox
oil and add oil if necessary.
1.
Move the machine to a level surface.
2.
Clean the area around the pipe plug and remove
the pipe plug from the gearbox
Note:
If needed, use pliers to assist in removing
the pipe plug.
2. Turnbuckle
(Figure
27).
(Figure
28).
g260109
3.
Check the oil level using a suitable measuring
device, such as a clean cable tie. The oil should
be approximately 3.8 cm (1.5 inches) below the
filler opening
4.
If the oil level is low, add GL-5 or GL-6, SAE
85-95 EP gear oil lubricant to the gearbox, then
check the oil level again.
Note:
Do not use synthetic oil.
5.
Install the pipe plug in the gearbox.
Changing the Engine Oil
Service Interval: After the first 5 hours—Change the
Yearly—Change the engine oil.
If possible, run the engine for a few minutes before
changing the oil because warm oil flows better and
carries more contaminants.
Engine oil capacity
Oil viscosity
API service classification
Use
Figure 30
below to select the best oil viscosity for
the outdoor temperature range expected:
19
Figure 28
(Figure
29).
Figure 29
engine oil.
1.10 L (37 fl oz)
Refer to
Figure
SJ or higher
g257725
g257737
30.
Hide quick links:
Advertisement
Table of Contents
