Replacing The Spark Plug - Toro Power Max 1428 OHXE Operator's Manual

1. Clean the area around the oil-drain cap
31).
1. Oil-drain cap
2. Slide an oil-drain pan under the drain extension
and remove the oil-drain cap.
3. Drain the oil.
Note:
Dispose of the used oil properly at a local
recycling center.
4. Install the oil-drain cap.
5. Fill the crankcase with oil.

Replacing the Spark Plug

Service Interval: Every 100 hours—Replace the
spark plug.
WARNING
Replacing the spark plug while the engine is
hot can result in burns.
Wait until the engine is cool to replace the
spark plug.
Figure 30
Figure 31
Use a Lawn-Boy spark plug or equivalent (Champion®
RN9YC or NGK BPR6ES).
1. Remove the boot
g011606
1. Spark-plug boot
(Figure
2. Clean around the base of the spark plug.
g016496
3. Remove and discard the old spark plug.
Note:
to remove the spark plug.
4. Set the gap between the electrodes on a new
spark plug at 0.76 mm (0.030 inch) as shown
in Figure
1. 0.76 mm (0.030 inch)
20
(Figure 32).
Figure 32
Figure 33
You will need a ratchet wrench extension
34.
Figure 34
g016645
g016646
g001029