Quadrone PRO Instruction Manual page 5

4ch 2.4g remote control quadcopter
Table of Contents

Advertisement

Forward/backward fine-tuning
When the quadcopter unintentionally flies
forward/backward, press the fine tuning
button up or down until the problem is
corrected.
MODE 2
Operation Instructions
Hover up and down
Push the throttle up or down to make the quadcopter
fly up or down
Turn left and right
Push the throttle left or right to make the
quadcopter turn left or right.
Forward/backward fine-tuning
When the quadcopter unintentionally
flies forward/backward, press the
fine tuning button up or down until
the problem is corrected.
Sideward fine-tuning
When the quadcopter unintentionally flies
to the left/right side, press the fine tuning
button left or right until the problem is
corrected.
Sideward fine-tuning
When the quadcopter unintentionally
flies to the left/right side, press the
fine tuning button left or right until the
problem is corrected.
Turn left/right fine-tuning
When the quadcopter unintentionally turns
to the left/right side, press the fine tuning
button left or right until the problem is
corrected.
Forward and backward
Push the direction lever up or down to make the
quadcopter fly forward or backward.
Sideward flying
Push the direction lever left or right to make the
quadcopter fly to the left side or the right side.
Turn left/right fine-tuning
When the quadcopter unintentionally
turns to the left/right side, press the
fine tuning button left or right until the
problem is corrected.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRO and is the answer not in the manual?

Questions and answers

Edward Azzopardi
February 7, 2025

As soon as I try to increase speed for take off it's going motors off. Is there any setting about the matter. Thanks

1 comments:
Mr. Anderson
February 10, 2025

The motors of the Quadrone PRO may turn off when trying to increase speed for takeoff due to two possible reasons:

1. Low-Voltage Protection – If the quadcopter's battery is low, the power supply to the rotors will stop automatically. Charging the battery may resolve this issue.
2. Power Surge Protection – If the rotating blades become jammed, the control system will stop supplying power to the rotors automatically. In this case, the signal needs to be rematched to fly again.

This answer is automatically generated

Table of Contents