Quadrone PRO Instruction Manual page 4

4ch 2.4g remote control quadcopter
Table of Contents

Advertisement

CAUTIONS WHEN CHARGING
1. Please keep this product in a dry, ventilated area away from any heat source or explosive product.
2. Please remove the battery from the quadcopter. Only charge under the supervision of an adult.
3. After flying, do not charge the battery until the battery has cooled down in order to avoid a swollen battery and
a fire hazard.
4. Please use the provided USB charging cable to avoid damaging the battery.
5. When not used for a long time, a battery can lose its charge. Avoid charging too often to maximize battery life.
1. Install the landing skids to the bottom of the quadcopter, then lock screws (Figure 1).
2. Install the blade protecting frame to every corner, then lock screws (Figure 2).
The remote features two built in modes, Mode 1 and
Mode 2. To change modes, flip the "B" button and then
restart the remote.
MODE 1
Operation Instructions
Forward and backward
Hover up and down
Push the throttle up or down to make the quadcopter
Push the direction lever up or down to make the
fly up or down
quadcopter fly forward or backward.
Sideward flying
Turn left and right
Push the throttle left or right to make the
Push the direction lever left or right to make the
quadcopter turn left or right.
quadcopter fly to the left side or the right side.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRO and is the answer not in the manual?

Questions and answers

Edward Azzopardi
February 7, 2025

As soon as I try to increase speed for take off it's going motors off. Is there any setting about the matter. Thanks

1 comments:
Mr. Anderson
February 10, 2025

The motors of the Quadrone PRO may turn off when trying to increase speed for takeoff due to two possible reasons:

1. Low-Voltage Protection – If the quadcopter's battery is low, the power supply to the rotors will stop automatically. Charging the battery may resolve this issue.
2. Power Surge Protection – If the rotating blades become jammed, the control system will stop supplying power to the rotors automatically. In this case, the signal needs to be rematched to fly again.

This answer is automatically generated

Table of Contents