Installing On Windows 8, 7 Or Vista - Multitech MultiConnect MTPCIE-H5 Series Developer's Manual

INSTALLING DRIVERS FOR NON-UIP HSPA+ DEVICES

Installing on Windows 8, 7 or Vista

This process installs multiple drivers and ports.
Note: If you previously installed USB drivers for this device, uninstall them before installing or re-installing this
driver. Uninstall all existing drivers for this device. Refer to
Before you connect the device (disconnect the device if you connected it):
CAUTION: If you connected the device before installing the drivers, Windows may install drivers automatically.
Your device may not operate correctly with these drivers. Uninstall the drivers before proceeding. See Remove
Microsoft Installed Drivers for details.
1. Go to the location where you extracted the driver and open the H5-G3-USB\Driver folder.
2. Right-click on TelitUSBInstaller_In_U8.00.04.exe and select Run as Administrator.
3. Click Yes or Allow to allow the installer to make changes to your computer.
4. Click Next and follow the instructions in the installation wizard.
5. Click the Install option when prompted, for example, Install this driver software anyway.
6. Click Finish.
7. Connect USB cable from the device to a USB port on your computer. Windows indicates when the device
is ready to use.
8. Signal strength LEDs require a device reboot after installing software. Disconnect the device from the
computer's USB port for a few seconds and reconnect the device to the same USB port.
70
Uninstall Windows Drivers
®
MultiConnect PCIe MTPCIE-H5/MTPCIE-BW Developer Guide
for details.