Installing The Device Driver - Hamamatsu Photonics C10507 Series Instruction Manual

【Installing the device driver】

For Windows XP, please install the device driver to the following procedures. It is installed automatically for
Windows 2000.
The device driver must be installed when you connect the MPPC module for the first time to the PC. If you
connect two or more MPPC modules to the PC, repeat the same procedure to install the device driver for
each MPPC module. When the PC has two or more USB ports and you connect the MPPC module to
another USB port, you will have to repeat the same procedure to install the device driver.
Connect the MPPC module to the PC. The MPPC
will be detected as new hardware and the "Found
New Hardware Wizard" will appear to guide you
through the device driver installation. Select "No,
not this time" and click [Next] to continue.
Select "Install from a list of specific location
(Advanced)" and click [Next] to continue.
* If you select "Install the software automatically
(recommended)" while the PC is connected to a
LAN, the PC will search for the device driver via
the network, possibly causing no response.
Always select "Install from a list of specific
location (Advanced)".
Select "Don't search I will choose the driver to
install" and click [Next] to continue.
< 13 >