Table of Contents
Advertisement
Available languages
Available languages
hOw TO CLEAN yOUR APPLIANCE
Meat left behind in the cutter housing may be removed from the inside of the appliance by
passing a slice of bread through the cutter housing.
1)
Before you clean the appliance, switch the appliance off and remove the plug from
the socket.
2)
Press the release button P25 and turn the whole cutter housing in the direction of the arrow.
Remove the pusher and the tray.
3)
Unscrew the screw ring and remove all parts of the cutter housing.
Do not clean the parts in the dishwasher!
4)
Wash all parts that have come into contact with meat in hot soapy water.
CLEAN THEM IMMEDIATELY AFTER USE.
5)
Rinse them with clear hot water and dry them IMMEDIATELY.
6)
We advise you to lubricate the cutter unit and the grinding discs with some vegetable oil.
TROUBLEShOOTING
•
The device is not working
•
Check that the mains connection cable is firmly plugged in.
•
Check the positions of the switches.
•
This appliance is equipped with a circuit breaker. This system will automatically cut off the
power supply to the appliance in case of the current is too large .
•
If your appliance suddenly stops running:
1/ Pull the mains plug out of the socket.
2/ Let the appliance cool down for 60 minutes
3/ Press the switch button to turn off the appliance.
4/ Press the circuit breaker button Z at the bottom of the appliance to turn on the appliance.
5/ Put the mains plug in the socket.
6/ Switch the appliance on again.
•
Please contact you dealer of an authorized service center if the circuit breaker is activated too
often.
TIPS
Lash down the power cord, then foist it into the pla-
ce with arrow diagramming. If the appliance is locked,
please press Reversal button (REV). The meat locked in
cutter housing is untrodden, so the appliance can renew
its usual condition.
The parts of P14, P15, P16, a P17 can be stowed in the
pusher.
ENG - 32
Advertisement
Table of Contents
