Heatstore HSCPF3000 Installation, Operation And Maintenance Instructions

CONNECTION TO THE MAIN SUPPLY
Electrical installation should be carried out by a competent installer, preferably registered with
NICEIC (National Inspection Council for Electrical Installation Contracting) in accordance with the
16 edition of the IEE Wiring Regulations, (BS.7671: 1992), and any relevant Local Authority Bye-
Laws.
This heater is fitted with a 3-core mains supply cable and should be permanently connected to
the electricity supply via a double pole switch having 3mm gap on each pole.
A switched Fused Connection unit to BS.1363. Part 4 is a recommended mains supply
connection accessory to ensure compliance with safety requirements applicable to a fixed-wiring
installation.
MAINTENANCE
ALWAYS ENSURE THAT THE MAIN EXTERNAL ELECTRICAL SUPPLY IS SWITCHED OFF BEFORE ANY
MAINTENANCE IS CARRIED OUT.
To obtain the best results from the heater, it is necessary to avoid any accumulation of dust or
dirt within the unit or on the air inlet grille. The unit should be cleaned regularly.
PROTECTION (Thermal Cut-out)
The units are protected from overheating in the event of fan failure, or an obstruction of the
free airflow, by an auto reset thermal cut-out. If this happens the thermal cut-out effectively
switches the appliance off. The appliance will not operate until it has cooled down. If this fault re-
occurs, refer to 'fault conditions'.
FAULT CONDITIONS
If the heater will not operate, disconnect it from the mains and arrange for a certified
electrician to attend to investigate the reason.
SAFETY
This equipment has been designed and manufactured to the highest international standards
but, like all electrical appliances which are operated by mains voltage, care must be taken if you
are to obtain the best results and safety is to be assured.
Do NOT use this appliance in bathrooms or where similar conditions of excessive moisture are
present.
No NOT handle the appliance with wet hands.
Do NOT use the appliance in an enclosed room so small that the heater will generate ambient
0
temperatures in excess of 30 C.
Do NOT use the appliance with young children unattended.
Do NOT use the appliance in rooms where excessive dust is generated or present.
Do NOT touch THE outlet grille when appliance is in use.
Do NOT cover or restrict any aperture of the appliance when in use.
Do NOT use the appliance if damaged.
If the appliance has been kept in freezing conditions, run at cold/fan setting for 5 minutes
before using heat settings.
This appliance meets the requirements of EU Directive 98/336/EEC for EMC.
Avon Riverside, Victoria Road, Avonmouth, Bristol BS11 9DB
Telephone: 0117 923 5375 Fax: 0117 923 5374
Avon Riverside, Victoria Road, Avonmouth, Bristol BS11 9DB
Telephone:
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS FOR
WALL MOUNTED FAN HEATER
Catalogue Numbers:
58000305 Iss 1
0117 923 5375
HSCPF3000/HSCPF3000T (painted steel fascia)
HSCPF3000BA/HSCPFT3000BA (brushed aluminium fascia)
PLEASE RETAIN THIS LEAFLET FOR FUTURE MAINTENANCE
Fax: 0117 923 5374