Troubleshooting
Type of failure codes
Failure type 2
usually comes from IPCs ( there could be some
exceptions). These failures affect the whole IPC, in
any case the user may continue to use the burners
that belong to the other IPC. When this type of
failure occurs than USIF becomes insensitive to
subsequent changes of settings on that IPC. If the
user presses the buttons related that IPC that
F23
presents the failure then a Long_beep is emitted.
Every failure type 2 (that concerns one IPC only) is
shown on the displays that are associated to that
IPC. Supposing to have the error coded with F23
for the IPC1, it will be shown intermittently a "F F",
a "2 3" on those displays.
(See pictures below- Each frame is showed for one
second on the USIF).
©
Service Competence Center