Download Print this page

Phil & Teds Inline Dash Survival Manual page 9

Advertisement

depress nib springs and insert hinge
ends into pull bar holes.
note
hinges are marked with L and R
denoting left and right when viewed from
behind buggy.
r
feed retaining strap beneath rear of sunhood,
loop it around handle and connect clip.
warning
never use baby & toddler buggy
without using retaining strap.
note
do not lift buggy using double kit.
damage to double kit hinges may occur.
s
double kit has a recline feature.
to activate: undo both zips that run around
rear of seat.
double buggy
t
to attach double kit to rear of buggy
(2 toddlers position): start with buggy
seat in upright position. remove hinges
from double kit. align double kit tubes
with supports on back of buggy frame.
depress nib springs on supports and slide
double kit on, ensuring nib springs pop
through holes on double kit frame. load
heavier toddler in front seat first, then
place lighter toddler in double kit at rear.
always unload rear toddler first.
warning:
never use double kit without
toddler in front seat.
folding
remove double kit if attached in rear position.
u
depress and hold in red safety button on
inside left of handle, whilst pulling up frame
release triggers on both sides, as shown.
allow seat back to fall backwards.
v
lift cross bar allowing front wheel to
fold under frame. press frame flat until fold
lock clicks into place.
add ` adapt
other products available for dash:
buggy covers
single and double stormy weather covers
single and double sunuy days covers
buggy beds and liners
cocoon
race seat liner
buggy bunny liner
snuggle & snooze sleeping bag
buggy storage
blazing saddles pannier bags
up & away buggy travel bag
hang bag & belt
shop & drop
4
lamb skin liner
sponge ted liner

Advertisement

loading