Advertisement
dash instructions
assembling your new phil`teds inline
is effortless and tool-free. just follow these
simple steps and in 5 minutes you'll be off!
bits ` bobs
red numbers below refer to buggy parts
indicated inside back flap of this guide.
1.
rear guards
2.
rear wheels
3.
sun hood
4.
front wheel
5.
rear axles
6.
handle/brake
7.
back flap
8.
footwell
9.
swivel lock
10.
harness
11.
auto frame lock
12.
fold lock release trigger
13.
wrist strap
14.
double kit (sold separately)
15.
retaining strap (comes with double kit)
safe ` sound
we've attained the following safety standards:
•
EN 1888:2005
•
AS/NZS 2088:2000
•
ASTM F833-07a
wheeling ` dealing
keep tyres inflated to 22PSI
dash
a
release fold lock by pushing in grey frame
TM
lock button.
b
attach rear guards by clipping them on
as shown.
c
insert axles into rear wheels
(from side without brake disk).
d
to attach rear wheels: depress silver
axle hub and insert wheel axle into buggy
axle housing.
e
lift footwell as far as hinge will allow.
f
to attach front wheel: fully extend swivel
lock knob and insert wheel rod into buggy
frame, as shown. release swivel lock knob
and check wheel is in place for use.
to place front wheel in swivel position:
rotate swivel lock 90
place (visibly extended).
to place front wheel in locked (non swivel)
position: rotate swivel lock 90
into place (no longer extended).
gettin' it together
g
turn buggy over onto 3 wheels. pull
handle up until you hear a resounding 'click'.
handle
dash is equipped with an intelligent handle that
incorporates multi adjustment and braking.
2
o
until it clips into
o
until it clips
Advertisement
