Summary of Contents for Fisher-Price Push'n Pedal Trike 72666
Page 1
Push'n Pedal Trike Model Number: 72666 Instructions Please keep these instructions for future reference. Adult assembly is required. Age: 1 years - 5 years Weight Limit: 50 lbs. Tools needed for assembly: Hammer, Phillips Screwdriver, Scrap Block of Wood...
Page 2
Consumer Affairs at the address indicated above and for all associated freight and insur- ance cost. Fisher-Price, Inc. will bear the cost of shipping the repaired or replaced item to you. This warranty is void if the owner repairs or modifies the product. This warranty excludes any liability other than that expressly stated above including but not limited to any incidental or consequential damages.
Page 3
Parts • Please save all packaging material until assembly is complete to ensure that no parts are discarded. • Please wipe each part with a clean dry cloth before assembly the Push ‘n Pedal Trike. #8 x 3" Screw - 1 #8 x "...
Page 4
Assembly Rear Wheel Assembly Frame Cap Nut Assembly Tool Axle Hole Axle Hole Straight Axle Straight Axle • Turn the frame upside down. • Insert the straight axle through the axle holes in the rear of the frame. Cap Nut Spoke Cap Nut Side Up...
Page 5
Pedal Axle and Front Wheel Assembly Pedal Hubs Pedal Hub Metal Tab Pedal Axle Metal Tab Slot Pedal Hub • Push the pedal hubs in until they are flush with the surface of the front wheel. • Place two pedal hubs on the pedal axle so that the metal tabs on the pedal axle fit into the slots inside each pedal hub.
Page 6
Front Wheel to Fork Assembly Footrest Assembly Frame Opening Fork Arms Pedal Axle Cover Groove Footrest ➥ Pedal Axle #8 x " Screw - 4 SHOWN ACTUAL SIZE • Place the front wheel assembly between the fork arms so that the pedal axle fits into the groove at the bottom of •...
Page 7
Parent-Assist Handle Assembly Hole Parent-Assist Handle Handle Grip Retainer with Screw Parent-Assist Holes Handle Grip Groove Parent-Assist Handle • Turn the frame upside down so that the parent-assist Curved Side handle rests on the floor. • Fit the handle retainer pin into the groove in the bottom of the frame and then into the hole in the bottom of the parent-assist handle base.
Page 8
Parent-Assist Handle Base Seat Handle Retainer Seat Retainer Pin • Remove the parent-assist handle from the frame. • While pushing down on the seat, insert the seat retainer pin through the hole in the seat and into a seat mount adjust- •...
Need help?
Do you have a question about the Push'n Pedal Trike 72666 and is the answer not in the manual?
Questions and answers