Table of Contents
Advertisement
SPECIFICATION OF PV CHARGE CONTROLLER
3.4.3 Connect loads to the controller
3.4.4 Confirm the wiring
3.4.5 Caution: If you want to remove the system, please follow
4. Operation
4.1 Instruction of HMI interface
A
B
C
After normal display of the LCD, then connect solar
panel to the solar controller
Note: Right connect the positive and negative
Caution: If there is no combiner in the system, we
require user to add a breaker between the controller and
PV arrays. And before you connect them, please ensure
that the breaker is off.
Warning: Risk of electric shock! The solar module's
high voltage output can cause severe shock or injury.
Be careful operation when installing solar wiring.
NOTE: Right connect the positive and negative
Double check the all the wiring steps above. Confirm
all connections are right and tightened. Then do the
next step.
the following steps strictly:
➢ Turn off the combiner or breaker between solar
module(s) and controller, then remove the solar
module(s) from controller first!
➢ Second move the battery
➢ Last move the load
D
6
E
F
G H
Advertisement
Table of Contents
