Table of Contents
Advertisement
SPECIFICATION OF PV CHARGE CONTROLLER
objects near the battery.
Note: By default, the controller works with Lead-acid battery,
GEL battery, AMG battery, etc. If you use Lithium battery,
please let me know before you buy it. We have special program
for lithium battery. We will do not take any responsibility for
problems when you use the controller with lithium battery.
Note: We suggest 10mm
3.2 Wiring instruction
From left to right of the connection terminal which in turn is
solar panel positive pole, solar panel negative pole, battery
positive pole, battery negative pole, DC output positive pole and
DC output negative pole, the diagram as following:
Solar Panel
S+
S-
3.3 Mounting
3.3.1 Choose mounting location
Mount the controller near to battery and on a safe
surface protected from direct sunlight, high temperature
and water, a best surface should with following
properties
* Stable * Ventilation * Non-flammable * Dry
Do no install the controller outside. The controller must
be mounted protected from moisture, dripping water,
spray, rainwater and direct or indirect heating, e.g. from
direct sunlight.
3.4 Wiring the controller to the system
3.4.1 Connect battery to the controller
Note: Right connect the positive and negative.
Warning: Risk of explosion or fire! Never short circuit
battery positive (+) and negative (-) or cables.
3.4.2 Connect solar panel to the controller
2
copper wire for wiring in the system.
Battery
B+
B-
5
Load
L+
L1
Advertisement
Table of Contents
