Threadihg lhe Machine
• Place spool of thread on spool pino If spool being
used has a thread retaining slit
A,
it should be placed
to the ríght,
as iIIustrated.
.
• Ralse the presser
toot,
to release thread tension.
• Raise the take-up lever to highest position by turn-
: ing hand wheel
toward vou.
,
~
Snap thread into thread guide post 1.
• Holding thread ends in each hand, snap thread into
. upper Ihread guide 2•
•, Pass thread through thread guide 3.
• With right hand on Ihread spool, Ihread the needle
thread tension 4. Slide Ihread over metal plate be-
. tween tension discs with left hand. Lead thread
under tension and tension wire. Thread tension wire
by (irmly pulling thread up and over to the righ"
• Guide thread through point S.
• Thread take-up lever 8, as illustrated.
• Draw thread through poínts 7 and 8, guiding thread
trom rear 01 each guide to the righ"
• Pass Ihread Ihrough guide 9. Thread the needle
10
trom Iront lo back, drawing lOCm(4 inches) 01 thread
Ihrough lhe needle
eve.
24