The Bobbin Thread
Winding lhe Bobbin
Preparation Steps
1. Raise the presser foot and turn hand wheel toward
you until needle isin highest position.
2. Loosen handwheel knob A by turning it toward you
with the right hand while holding hand wheel with
the left hand.
3. Place thread spool on spool pin with thread retain-
ing slitB to the right. (Break paper at the end of
spool if necessary.)
• PlacespoolholderC on spoolpinand press firm/y
againstthe thread spool.
Winding Steps
• Snapthread into thread guide post
o
and open top
cover.
• Lead thread around bobbin winder tension disc E;
as illustrated, and throughsmall hole in bobbinfrom
insideout.
• Place bobbin on spindle and move bobbin winder
F to right.
• Hold thread end and start the machine. Cut off
thread end after a few coils have been wound.
• When required amount of thread has been wound
(winding will stop when bobbin ís full) stop machine
and cut connecting thread.
• Move bobbin winder to the left and remove bobbin.
• Hold hand wheel and tighten hand wheel knob.
20