Singer Merritt 2404 Instruction Book page 83

Changing the Light Bulb
CAUTION:
Betore changing /ight bulb make sure
you have disconnected power /ine plug trom socket
outlet. This machineis designed to use
a
15-watt max-
imum bayonetbase bulb only.
The screw located on the machine face plate must
be removed before the face plate can be opened.
• Remove face plate.
• Do not attempt to unscrew the bulb.
1. Press it up into the socket and at the same time turn
bulb over in direction shown to unlock the bulb pin
and guide out of.. socket.
• Press new bulb into socket, with bulb pins ente r-
ing slot ot socket.
2.
Turn it over in direction shown to lock bulb in
position.
• Replace face plate.
Replacing the Slide Plate
Vou will not have any occasion
to
remove the sUde
plate. However, if it should accidentally become dis-
engaged from the machine, it is easily replaced.
• Raise the presser toot and make sure needle is in its
highest posítlort. "
• Place slide plate in slide way with the front edge
close to, but not covering, the retaining spring (as
shown).
• With a small screwdriver, lift each end ot the spring
into each ot the side qrooves on the underside ofthe
plate .
• Draw the plate gently toward you and fully engage
the spring.
• Close slide plate.
82