Trouble Indications - Toshiba TLP380 Owner's Manual

Trouble indications

If there is some problem inside the projector,
the indicators light up or blink.
Indicators
ON / STANDBY
VOL / ADJ
Control panel
(Main unit side)
The power does not come on.
→ Malfunction of the unit.
(Off)
• Unplug the power cord and call the dealer.
Or
(Lit in red)
The lamp turns off or does not light up.
→ The projector will return to the standby mode in about 2 minutes.
If the projector does not operate normally when the power is switched on again,
(Lit in red) the lamp is at the end of its life duration or the unit has a fault.
(Lit in red)
• Lamp's life duration is over, replace the lamp with a new one.
• Unplug the power cord and call the dealer.
The power turns off or does not come on.
→ The inside is too hot, or the projector has been working in an area of high
(Lit in red)
(Lit in red) (Lit in green)
temperature.
• Place the projector correctly so the intake and exhaust fan's holes are not covered.
Or
(Lit in orange)
• Turn the projector off, and leave it for a while, and turn it on again.
• Clean the air filter.
Or
(Lit in green)
* The
Or
* The projector returns to the standby mode after the fault display has been shown
(off)
for about 2 minutes.
The power turns off or does not come on.
→ Trouble with the cooling fan.
• Unplug the power cord and call the dealer.
(Lit or flashing
(Lit in red)
in red)
* The
Or
* The projector returns to the standby mode after the fault display has been shown
(Lit or flashing
in orange) for about 2 minutes.
The power turns off or does not come on.
→ The lamp cover is not properly attached.
(Flashing
(Lit in red) • Unplug the power cord and reattach the lamp cover.
in orange)
* The
* The projector returns to the standby mode after the fault display has been shown
for about 2 minutes.
Notes
• If abnormality occurs while operating, unplug the power cord.
• When reinserting the power cord before the lamp has cooled, please wait until the lamp has cooled sufficiently
before use. When the lamp is at a high temperature, it may not light and the life duration will be shortened.
63
icon appears before the power turned off.
icon appears before the power turned off.
icon appears before the power turned off.
62
CONTENTS
66
67