Macnaught P3 POWERLUBE Instruction Manual

PA62
0206
0007
INTRODUCTION
Thank you for purchasing either a P3 Power-Lube or
P6 Maxi-Lube air operated, high pressure grease pump.
Both the Power-Lube and the Maxi-Lube feature a
non-corroding 50:1 ratio air motor and are supplied with
drum lid, rubber edged follower plate, grease strainer,
4m high pressure grease hose, 'Z' type swivel and a B2
Booster Gun as standard equipment.
A full range of greasing accessories are available to suit
the Power-Lube or Maxi-Lube. Consult your local
Power-Lube distributor for more informatin
Please read and retain this instruction manual to assist
you in the operation and maintenance of this quality
product.
GENERAL INFORMATION
This manual assists you in operating and maintaining your
new Power-Lube or Maxi-Lube. The information contained
will help you ensure many years of dependable
performance and trouble free operation.
Please take a few moments to read through this manual
before installing and operating your Power-Lube or
Maxi-Lube. If you experience problems with the product,
refer to the Maintenance and Trouble Shooting sections of
this manual. If you require any further assistance please
contact your local Power-Lube or Maxi-Lube distributor.
IMPORTANT INFORMATION
Read this information carefully before use.Your safety
is important to us. Please read and follow all operating
and safety instructions listed below.Make sure all
operators have adequate access to the following
instructions.
CAUTION
This is a 50:1 ratio high pressure grease pump. Because
of the high pressures developed by this pump, the
possibility of fluid injection into the flesh, or eyes, is a
potential hazard.
Never allow any part of the human body to come in front
of, or in direct contact with a material outlet. Never point
the nozzle of the gun at yourself or anyone else.
Most injections occur because of component rupture. Never
exceed the pressure rating of any component in the
system. Remember, fluid pressure generated is fifty times
the air inlet pressure.
P3 POWERLUBE / P6 MAXILUBE
AIR OPERATED GREASE PUMPS
INSTRUCTION MANUAL
Weak, worn or damaged hoses are also a hazard. Before
operation check hoses for signs of wear, leaks or loose
fittings. Tighten all fluid connections regularly and replace
weak or damaged hose. Your personal safety and well
being are at stake.
If accidental injection should occur, seek immediate
emergency medical attention.
Do not use air pressure greater than 1035kPa /150psi /
10.3bar
Do not hit the unit if it fails to operate.
CAUTION
Before attempting any maintenance or repairs of this
product, disconnect air supply then squeeze gun trigger
to release pressure.
ASSEMBLY
This carton contains an Air Motor / Suction Tube assembly
(Pump unit), Lid, Follower, High Pressure Grease Hose,
B2 Booster Gun / Swivel assembly and a plastic bag
containing 3 slotted screws and an instruction sheet.
1) Remove the components from the protective packaging.
Reposition the 3 lid positioning screws so the threaded
ends are flush with the inside of the lid (Fig 1).
2) Slide the suction tube through the lid. Line up the holes
in the lid with the threaded holes in the air motor base,
so that the grease outlet of the pump faces one of the lid
handles (Fig4). This allows easy fitting and removal of
the air -line. Secure the lid to the air motor with the 3
slotted screws provided (Fig 2).
1