POWERGUN
Lithium-ion Battery Operated Grease Gun
Introduction
The
Macnaught
Lithium-ion
operated grease gun is a portable high pressure,
high volume grease gun, supplied complete with
2 x Lithium-ion batteries, battery charger, 1m
long flexible extension and carry case.
Important Information
Visually inspect grease gun, charger and battery
prior to use for any signs of damage, loose or
missing parts. If equipment is worn or damaged,
remove it from service. Contact an authorized
service centre or distributor
WARNING
IMPORTANT INFORMATION
Please read this information carefully before use.
'Cautions' are listed throughout this manual to advise
of actions to which may cause damage to your
equipment.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury. The
term "power tool" in all of the warnings listed refers to
your battery operated (cordless) power tool.
Make sure all operators have adequate access to the
following instructions.
GENERAL SAFETY
Keep work area clean and well lit.
DO NOT operate power tools in explosive areas,
e.g; close to flammable liquids, gases or dust.
ELECTRICAL SAFETY
Never modify electrical connections.
DO NOT expose power tool to rain or wet conditions.
Keep cord away from heat, oil, sharp edges or
moving parts.
PERSONAL SAFETY
DO NOT use a power tool while you are tired or
under the influence of drugs, alcohol or medication.
PG450 IM Issue 3 © 2017
™
INSTRUCTION MANUAL
PG450
Battery
(PG450)
POWER TOOL USE AND CARE
DO NOT force the power tool.
DO NOT use power tool if the power tool is damaged
or the switch does not turn the gun on and off.
Only use this power tool in accordance with the
instructions provided.
Battery and Charger Safety Information
WARNING
If battery-pack case is damaged DO NOT charge.
Danger of electric shock or electrocution
DO NOT probe the unit - Danger of electric shock or
electrocution.
The battery charger MUST NOT be used for any
other use than for charging the rechargeable
batteries supplied with the PG450
DO NOT operate charger with a damaged power
cord or plug, replace immediately.
DO NOT operate charger if it has received a sharp
blow, or has been dropped. Take it to an authorized
service centre.
DO NOT disassemble charger.
DO NOT store or use the tool and battery pack in
locations where the temperature may reach or
exceed 40°C/104°F.
DO NOT use charger on any other voltage than
designated on the charger. 120/230/240 volts
present at charging terminal
Page 1