Macnaught BG100 Instruction Manual

BG353
1108
0011
BG100 BATTERY OPERATED GREASE GUN
INTRODUCTION
Thank you for purchasing a Macnaught BG100 Battery
Operated Grease Gun.
The Macnaught BG100 Battery Operated Grease Gun is
designed to give continuous reliable greasing to pressures
up to 5000 psi. The BG100 is suitable for bulk, cartridge or
grease pump filling with greases up to and including NLGI
No2 consistency.
A wide range of Macnaught greasing accessories including
Flexible Extentions, Needle Point Couplers, Adaptors and
Button Head Couplers are available from your Macnaught
dealer
Please read and retain this instruction sheet to assist you in
assembly and maintenance of this product.
OPERATION
The BG100 Battery operated grease gun will give continuous
grease flow when the trigger is pressed. Grease flow will stop
when the trigger is released.
WARNING
IMPORTANT INFORMATION
Read this information carefully before use. Failure to follow all
instructions listed below may result in electric shok, fire and/or
serious injury. The term "power tool" in all of the warnings
listed refers to your battery operated (cordless) power tool.
Make sure all operators have adequate access to the follow-
ing instructions.

GENERAL SAFETY

WORK AREA
1) Keep work area clean and well lit. Cluttered and dark areas
invite accidents
2) DO NOT operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Power tools create sparks, which may ignite the dust
or fumes
3) Keep children and bystanders away while operating a power
tool. Distractions can cause you to lose control.
ELECTRICAL SAFETY
4) Power plugs must match the outlet. Never modify the plug in
any way. Unmodified plugs and matching outlets will
reduce the risk of electric shock.
5) Avoid body contact with earthed or ground surfaces such as
pipes radiators, ranges and refrigerators. There is an
increased risk of electric shock if your body is earthed or
grounded

INSTRUCTION MANUAL

6) DO NOT expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
7) DO NOT abuse the power cord. Keep cord away from heat,
oil, sharp edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
PERSONAL SAFETY
1) Stay alert, watch what you are doing and use common
sense when operating a power tool. DO NOT use a power
tool while you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention while
operating power tools may result in serious personal injury.
2) Use safety equipment. Always were eye protection. Safety
equipment such as dust mask, non skid safety shoes, hard
hat, or hearing protection used for appropriate conditions
will reduce personal injuries.
3) Avoid accidental starting. Carrying power tools with your
finger on the switch invites accidents.
4) DO NOT over reach. Keep proper footing and balance at all
times. This enables better control of the power tool in
unexpected situations.
5) Dress properly. DO NOT wear loose clothing or jewellery.
Keep your hair, clothing and gloves away from moving parts.
Loose clothes jewellery or long hair can be caught in
moving parts.
POWER TOOL USE AND CARE
6) DO NOT force the power tool. Use the correct power tool for
your application. The correct power tool will do the job
better and safer at the rate for which it was designed.
1