Using The Remote Control; Changing The New Lithium Battery; Operating The Remote Control - Toshiba TDP-FF1A Owner's Manual

Using the remote control

Changing the new lithium battery

 Remove the battery compartment.
 Insert the battery compartment.

Operating the remote control

Turn on the projector and then the remote control can be used to adjust the OSD,
volume, and input select.
Note
• The remote control is shipped with a plastic sheet between the battery and its contact.
Pull on the sheet to remove it from the remote control.
• Remove the battery from the remote control when it will not be used for an extended
period.
Battery
• Before using the battery, please refer to the notes on
• If the remote control stops working, or if its range decreases, replace the battery with new
one.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang it.
• Do not leave it in hot or humid locations.
• Do not get it wet or place on top of wet objects.
• Do not take it apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
 Replace the lithium battery.
Be sure to align the battery according to
the polarity.
.
22