Projection Adjustments – Image; Camera - Toshiba TDP-ET20 Owner's Manual

Adjustments
Projection adjustments
– Image
Preparation
• Display the image as explained in "Picture
Projection".
21
• Set the POINTER/PJ selector to "PJ".
SELECT/ADJUST
ON/STANDBY MENU ENTER
AUTO SET ON/STANDBY
KEYSTONE
MARKER LASER
POINTER
1,7
PJ
L-CLICK R-CLICK
MENU ENTER
RGB VIDEO CAMERA
RESIZE RESET FREEZE
1
Press MENU to display the
menu.
2
Press or to select
ON
INPUT
LAMP
3
Press
TEMP
4
Press ENTER.
The image is automatically adjusted.
AUTO SET
For further adjustments, follow the below
steps.
2,3,5,6
5
Press
4
preferred item.
6
Press
RESET
item.
To select another item, go back to step 5.
Phase:
H-position: To shift the image to the
V-position: To shift the image down (–),
. Clock
7
Press MENU.
The menu disappears.
I ma g e
A u t o s y n c .
P h a s e – +
H – p o s i t i o n
– +
V – p o s i t i o n – +
C l o c k – +
to select "Auto sync."
or to select a
or to adjust the
To reduce flickers.
left (–), to the right (+).
to up (+).
To remove vertical stripes.
CONTENTS
Notes
• When performing the automatic projection
adjustment, use a bright and distinctly edged
picture.
• Pressing AUTO SET on the remote control
can also adjust the image automatically.
• If you project an image from a computer with
an LCD screen while monitoring the image on
the computer, the image may not be projected
properly, depending on the computer model.
In this case, turn off the computer display, or
make the necessary picture adjustments on
the projector. For details on controlling the
computer display, etc., refer to the computer's
manual and description on the software for
the computer used.
• During adjustments of "H-position" or "V-
position", the image may not be projected
properly.
• While using, an aberration of the phase may
occur. In that case, adjust "Phase" again.
• Some item may be displayed in gray
depending on an input source. The item
displayed in gray cannot be adjusted and/or
set.
• These adjustments are stored until you turn
the power off.
• To store the adjustments even if the power is
turned off, follow the procedure of "Saving
data".
34
• Pressing RESET will return the adjustment or
setting currently selected to default.
31
23