Table of Contents
Advertisement
The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
Due to some functions are not available for certain input signals, an icon
the screen when the button press is not effective.
1
2
3
4
5
6
MENU
7
+
8
-
8.
PIP and POP buttons
To turn the PIP or POP function on or off, press the PIP or POP button. Adjust the size of the PIP
image by pressing the + or - button. If you want to switch between the two windows, toggle SWAP so
that you can adjust the image settings in the selected window.
9.
FREEZE
Pauses the image.
10. LIGHT
Turns the remote control's backlight on.
14
Overview
1.
ON/STANDBY
Press and hold this button to turn the projector on when it is in the
standby mode. Or press this button twice to turn the projector off.
2.
INPUT buttons
Selects an input source to display on the projector.
3.
SCREEN SIZE buttons
Selects the image aspect ratio to suit the input signal.
4.
PICTURE MODE selection buttons
Restores settings saved in memory locations 1, 2, and 3 or restores
the default modes for the current input source, Dynamic, Standard,
Theater 1, or Theater 2.
5.
Arrows ( / / / )
Used to select the desired menu or to make adjustments.
9
Opens the selected items of the menu.
6.
MENU
Turns the on-screen display control menu on or off.
10
7.
Picture quality adjustment buttons
p.23
p.26
,
p. 20
p. 24
p. 20
p.26
Enter button
p.26
p.26
,
p. 32
p.27
p.23
p.26
will appear on
Advertisement
Table of Contents
