Table of Contents
Advertisement
Storing stations
After locating a station, you can
store it as follows:
➔
Select the desired memory
bank (see page 85).
➔
Press the softkey for approx.
two seconds to which you
want to assign the station.
The station is stored. A signal
tone confi rms that the station
has been stored.
The display briefl y shows the
assignment of the six memory
locations of the current memo-
ry bank. The current station is
highlighted.
Note:
To automatically search for
FM stations and store them in
the FMT memory bank (Travel-
store), see page 90.
Listening to stored
stations
➔
Select the desired memory
bank (see page 85).
➔
Briefl y press the softkey which
is assigned to the station you
want to set up.
The display may briefl y show
the assignment of the six mem-
ory locations of the current
memory bank. The current sta-
tion is highlighted. The desired
station is played back provided
that it can be received at the
current vehicle position.
➔
Press the OK button
@
ESC button
16 seconds.
The tuner display shows sta-
tion name, frequency and ra-
dio text of this station, provid-
ed that the station broadcasts
RDS information.
In addition, the memory loca-
tion of the radio station
highlighted.
Scanning all receivable
stations
➔
Select the waveband (FM, MW,
LW) whose receivable stations
you want to scan (see page 89).
➔
Press and hold the OK button
A
for approx. two seconds.
The tuner searches for stations
in the current waveband. The
display shows "SCAN" every
two seconds.
As soon as the tuner has locat-
ed a station, it is played and
the station name or the station
frequency appears on the dis-
play. The scan time can be set
as described on page 120 and
121 under "Scan Time".
After the frequency band has
been completely searched
Operating the tuner
A
or the
or wait for
F
is
87
Advertisement
Table of Contents
