Leds - NETGEAR GS724TPv2 Hardware Installation Manual

24-Port Gigabit (Hi-Power) PoE+ Ethernet Smart Managed Pro Switch with 2 SFP Ports
Table 1. Front panel components (Continued)
Number Description
5 2 dedicated SFP fiber ports in which you can install GBICs for fiber connections.
For more information, see SFP ports for fiber connectivity on page 16.
6 Factory Defaults button (model GS724TPv2 only).
For more information, see Dual-function Factory Defaults button (model GS724TPv2) on page 17.

LEDs

This section describes the LEDs on the front panel of the switch.
Table 2. Front panel LEDs
LED
Power LED
Fan LED
PoE Max LED
RJ-45 upper LEDs 1–24
These LEDs indicate the link
status, speed, and activity
of an associated port.
RJ-45 lower LEDs 1–24
These LEDs indicate the
PoE status of an associated
port.
Link and ACT LEDs 25F–26F
Hardware Overview
Description
Solid green. The switch is powered on.
Solid amber. The switch is booting.
Off. Power is not supplied to the switch.
Solid amber. The internal fan failed.
Off. The internal fan is operating normally.
Off. Sufficient (more than 7W of) PoE power is available.
Solid amber. Less than 7W of PoE power is available.
Blinking amber. At least once during the previous two minutes, less than 7W
of PoE power was available.
Off. No Ethernet link is established.
Solid green. A 1000 Mbps Ethernet link is established.
Blinking green. The port is transmitting or receiving packets at 1000 Mbps.
Solid amber. A 10 Mbps or 100 Mbps Ethernet link is established.
Blinking amber. The port is transmitting or receiving packets at 10 Mbps or
100 Mbps.
Off. The port is not delivering PoE.
Solid green. The port is delivering PoE.
Solid amber. A PoE fault occurred. For more information, see PoE
troubleshooting suggestions on page 34.
Off. No SFP module link is established.
Solid green. A 1000 Mbps link is established.
Blinking green. The SFP fiber port is transmitting or receiving packets at 1000
Mbps.
14 Hardware Installation Guide